Invest in some knee highs. Place top of knee high around base of slotted sleeve. Pull up so that only the top is firmly around base. Give it a try. You will be amazed!!! Nothing escapes. My pool is so clean. It even captures algae.
Jun 14, 2022 Rating
bag installation by: admin
make sure the bag is installed properly. Bags only go on one way
Jun 14, 2022 Rating
Disappointed by: Anonymous
I had an aquabot, and it would pick up all the very fine debris. I ordered the ultra fine filter for the triton, but it still just blows most of it back out.
Dec 28, 2016 Rating
Loose bag bad by: ADMIN
If the bag is loose then the pump will pull it off the bottom plate causing debris to escape.
Dec 28, 2016 Rating
by: ADMIN
If the bag is loose then the pump will pull it off the bottom plate causing debris to escape.
Dec 19, 2016 Rating
Bag on DOphin deluxe 4 by: DD
Is it really that important that the bag fits in there perfect? I cut the band off it because it broke. What was that band for? How would it affect leaves sneaking into the motor area and no leaves going in the bag. It's climbing the walls and the impeller is blowing trash leaves and small sticks out the top. Crazy!!!
Jul 07, 2016 Rating
Spreading everything around by: Anonymous
Mine is doing the same thing, did you figure it out ? It just spreads everything around
Jun 19, 2016 Rating
Must have suction by: ADMIN
You are correct that climbing is only possible with suction and where there is suction there is intake. You may have a poorly fitting bag or even a hole in the bag. Otherwise the robot appears to be working normally.
Jun 15, 2016 Rating
It does climb walls by: Anonymous
It does climb the walls. It acts normally but doesn't pick up anything
Jun 14, 2016 Rating
Dophin Vacuum Issue by: Anonymous
Just curious, would the unit climb the walls if the pump wasn't working properly. I would not think there would be enough suction to climb the walls.
Just a thought.
Mike t
Jun 13, 2016 Rating
looks like the impeller is spinning. by: Anonymous
It looks like the impeller is spinning. Really weird
Jun 13, 2016 Rating
by: ADMIN
If your pump is not spinning the impeller then the pump is bad or the connection is bad. Unfortunately, Maytronics does not sell the motors to repair your machine.