I am looking for the electrical schematics for the controller. I had to replace the cord between the controller and the propeller motor as it got crimped. Now the vacuum will only go one direction. I can hear the controller click and then the motor stops. It turns freely by hand in either direction. I put a multimeter on the outlet plug to the motor and I initially get voltage and then the click and it goes to zero. I took the controller apart and the best I can guess is the single relay srd-05vdc-slc is bad in that direction (there are two beside the out1 and out2). But not sure if I can pull it. Is it soldered into place or just held with the pins? Would appreciate any help you can provide as everything else on the unit works and don’t want to have to buy a new one.
